Knowledge Base:  

Knowledge Base : attenuator
Page of 1
Is there an attenuator built-in on RIGOL's DSA815?
Yes, but you should still take care never to exceed the DSA815's max input power or voltage (+20dBm or 100mW and 50VDC abs. max - pulsed waveforms can easily exceed this e.g. direct from a LISN - see
How do i measure an RF Attenuator?
How to measure an RF Attenuator Using a DSA815-TG Spectrum Analyzer This document provides step-by-step instructions on using the Rigol DSA-800 series of Spectrum Analysers to measure the characteris
Is there an attenuator built-in on RIGOL's DSA1030?
Yes, but you should still take care never to exceed the DSA1030's max input power or voltage (+30dBm or 1000mW and 50VDC abs. max - pulsed waveforms can easily exceed this e.g. direct from a LISN). Th
EMC Precompliance: Testing on a budget
EMC Precompliance: Testing on a budget Date:29.05.2012 Solution: Almost any electronic design slated for commercial use is subject to EMC (Electromagnetic Compatibility) testing. Any company int
RIGOL DG4062 Wave generator simulates heartbeat, for life-saving pacemaker medical technology... with help of RIGOL-UK's Team Telonic Instruments Ltd.
-- An example illustration of Twelve-lead ECG of a 26-year-old male A cost-beating means of simulating heart beats has emerged as another new application for RIGOL-uk.co.uk, this time using a RIGOL w
RIGOL 3GHz Spectrum Analyser - Applications insights from RIGOL-UK's customers.
1. Simple modulation testing above UHF. First I get straight on with monitoring typical modulation sidebands, I’m at 2,320MHz with DSA1030A-TG3 - a performance spectrum analyser from RIGOL incor
test
How to measure an RF Attenuator using a DSA815-TG Spectrum Analyzer Solution: This document provides step-by-step instructions on using the Rigol DSA-800 series of Spectrum Analysers to measure the c
How to get the specified DANL of -135dBm? (typ, +6dB f/GHz)
A simple sequence of settings will help you dig into the noise floor. With any Spectrum Analyser, setting up the (1) Span, (2) Attenuator, (3) Pre-amp and (4) Resolution Bandwidth settings - these are
How to reduce or lower noise floor? (DSA815 and DSA1030)
A simple sequence of settings will help you dig into the noise floor. With any Spectrum Analyser, setting up the (1) Span, (2) Attenuator, (3) Pre-amp and (4) Resolution Bandwidth settings - these are
How do I achieve the lowest DANL with my spectrum analyser?
Set your DSA as follows: Attenuator = 0dB; Preamplifier ON; Center Frequency = 10MHz; RBW = 10Hz; Span = 10KHz. This is a typical procedure for all professional analysers.